4-MMC from 4-methylbenzaldehyde via Grignard reagent

G.Patton

Expert
Joined
Jul 5, 2021
Messages
2,412
Solutions
3
Reaction score
2,381
Points
113
Deals
1

Introduction.

4-MMC(3) was synthesized as outlined in pictures below. Reaction of the 4-methylbenzaldehyde with ethyl magnesium bromide, followed by oxidation with pyridinium chlorochromate (PCC) on silica gel and bromination with hydrobromic acid/hydrogen peroxide afforded the lachrymatory bromo ketone(2), which were used without further purification. It was reacted with ethanolic methylamine in acetonitrile to produce 4-MMC, which were purified by flash chromatography. The free bases were converted to their hydrochloride salt with ethereal hydrogen chloride to afford (3). This method also may be used to synthesize 2- and 3-MMC (n-methylmethcathinone). This synthesis can be easily scaled up because not takes elaborate glassware and hard manipulations. Unfortunately, according to literature data, this method has low yield. Relying on my synthetic experience, I think that reaction yield can be increased by expand of a batch load.

Equipment and glassware:

200 ml pear-shaped or round bottom flask;
100 ml Separator funnel;
Beaker 100 ml (x2) and 50 ml;
Nitrogen balloon;
Magnetic stirrer (volume depends on batch);
Aspirator;
Ice bath (0 °C);
Buchner flask and funnel;
Filter paper;
Measuring cylinder for 100 ml and 20 ml;
Retort stand and clamp for securing apparatus;
Small conventional funnel (d 5-10 cm);
Graduated pipette 10 ml x2 or dispenser for 5-10 ml;
Laboratory scale (0.1 g-100 g is suitable);

Reagents:

4.2 g 4-Methylbenzaldehyde;
34 g Pyridinium chlorochromate (PCC) on silica gel 33%;
60 ml THF;
8 g Ethyl magnesium bromid (Grignard reagent);
200 g Anhydrous MgSO4;
50 ml Aqueous hydrochloric acid 2M (7.3%) (HCl);
350 ml Dichloromethane (DCM);
10.8 ml Aqueous hydrobromic acid (48 wt.%, 64 mmol, 5.18 g);
7.25 ml Hydrogen peroxide (30 wt.%, 64 mmol, 2.18 g);
1.34 ml Ethanolic methylamine (8M, 10 mmol);
3.5 ml Acetonitrile;
62 ml Diethyl ether;
15 ml Ethereal hydrogen chloride in (2M).

Procedure.

2-Bromo-1-(4-methylphenyl)propan-1-one (2).
A solution of 4-methylbenzaldehyde(1) (35 mmol, 4.20 g) in THF (20 ml) was added slowly to a mixture of ethyl magnesium bromide (3M in diethyl ether, 20 ml, 60 mmol, 8 g) and THF (20 ml) under nitrogen at room temperature. The mixture was allowed to stir overnight at room temperature. Excess Grignard reagent was decomposed by the cautious addition of water, and the mixture was evaporated to dryness under vacuum. The residue was partitioned between 2M (7.3%) aqueous hydrochloric acid (HCl) and dichloromethane (DCM). Drying (MgSO4) and removal of solvent afforded colourless oil, which was dissolved in dichloromethane (100 ml).
6bHpvc8kWG
This was added to pyridinium chlorochromate on silica gel (34 g, 33% PCC). The mixture was allowed to stir overnight at room temperature and the solvent was removed to afford an almost colourless oil to which concentrated aqueous hydrobromic acid (48 wt.%, 10.8 ml, 64 mmol, 5.18 g) was added.
Mj7LKoXa4f
The mixture was cooled in an ice bath (0 °C) and, with vigorous stirring, hydrogen peroxide (30 wt.%, 7.25 ml, 64 mmol) was added over 20 min. The mixture was allowed to warm to room temperature, left stirring overnight and worked up by extraction into dichloromethane, drying (MgSO4) and evaporation to give a yellow oil: 2-bromo-1-(4-methylphenyl) propan-1-one(2), 84% yield from 4-methylbenzaldehyde(1). These were used without further purification.
NYvyGaSZPf
4-MMC(3).
A mixture of ethanolic methylamine (8M, 1.34 ml, 10 mmol) and acetonitrile (1.5 ml) was added to a solution of 2-Bromo-1-(4-methylphenyl)propan-1-one(2) (5 mmol, 1.14 g) in acetonitrile (2 ml). After stirring for 30 min at room temperature, the mixture was added to diethyl ether (50 ml) and filtered.
HatA1vhsWZ
The solvent was removed under vacuum, the residue purified by flash chromatography (methanol:dichloromethane, 1:9) and the product was converted to the hydrochloride salt with ethereal hydrogen chloride in (2M) to afford product as white powder: 2-(methylamino)-1-(4-methylphenyl) propan-1-one hydrochloride(3) (289 mg, 27%), m. pt. 249–252 °C
 
Last edited by a moderator:
  • Free product samples

    Testing products from new vendors and manufacturers.

    Get free samples for testing now!

  • Always stay in touch with BB forum. Element/Matrix.

    Connect notifications to always stay in touch with the forum!

    Connect

  • The BB Forum team is looking for cooperation:

    • Traffic arbitrage specialists
    • Spammers
    • Advertising agencies
    • Bloggers/Vloggers
    • TOR sites directories
    • Creative people who can create viral content
    • Administrators of Telegram Channels and Groups

      We will pay more for your traffic than our competitors! $0.1 per visitor!!!If you are interested in, write to the administrator.
Top