- Language
- 🇺🇸
- Joined
- Jan 29, 2025
- Messages
- 9
- Reaction score
- 2
- Points
- 3
So far what I have in mind is:
Buy CBD isolate, A4 Zeolite and what I wanted was methanol but that isnt available for me so I assume ethanol as a solvent, CO2 gas.
Mix CBD isolate and Zeolite 1:2 put in an airtight container and replace air with CO2, heat for I dont remember how long right now, but I think at 80C.
Then filter wash with the ethanol solvent and afterwards evaporate the ethanol.
Is this correct and a good idea? Also could someone please describe how the product is affected by different ratios and conditions? Also would the end product of this procedure be an oil that I can put in a cart or do I need to do something else like decarb? I would assume after all the heating it should already be decarbed right?
Buy CBD isolate, A4 Zeolite and what I wanted was methanol but that isnt available for me so I assume ethanol as a solvent, CO2 gas.
Mix CBD isolate and Zeolite 1:2 put in an airtight container and replace air with CO2, heat for I dont remember how long right now, but I think at 80C.
Then filter wash with the ethanol solvent and afterwards evaporate the ethanol.
Is this correct and a good idea? Also could someone please describe how the product is affected by different ratios and conditions? Also would the end product of this procedure be an oil that I can put in a cart or do I need to do something else like decarb? I would assume after all the heating it should already be decarbed right?
- Language
- 🇺🇸
- Joined
- May 19, 2024
- Messages
- 93
- Reaction score
- 30
- Points
- 18
bro all of these are the kind that u can find decently pure at ur nearest store but u cant rl cyclise the cbd with co2 just get ptsa or AlCl or hcl or mayby a idea of what ur trying to go for since i can tell u the d9/8 synth cant look easy but can be realy shitty in not clean and not controled conditions (also do some more research since ur fumbling more things around than a 8th grader during a chemistry test )
↑View previous replies…
- Language
- 🇺🇸
- Joined
- Jan 29, 2025
- Messages
- 9
- Reaction score
- 2
- Points
- 3
So you are suggesting to use one of these two dry reagents right. In that case what should the ratio of the reagents be and how long should I heat it for? And with those should I use ethanol or something else like DCM or n-heptane?
- Language
- 🇺🇸
- Joined
- May 19, 2024
- Messages
- 93
- Reaction score
- 30
- Points
- 18
tolulene worked best for me and for the ptsa to get d8 a ratio of 1mmol cbd to 2 mmol ptsa while at 50c was pretty good.
- Language
- 🇺🇸
- Joined
- May 19, 2024
- Messages
- 93
- Reaction score
- 30
- Points
- 18