fluorinated amphetamines

[sadow]

What amphetamines can be insufflated? In psyconautwiki there are some that show inflated consumption and others not? I have 3-fma that they gave me by mistake and when insufflating it is very painful and in the wiki it does not have insufflated consumption. They made a mistake in the order. I bought pellets. Any recommendation? I haven't used amphetamine in like 6 years and I don't remember if it hurt that much.

maybe my nose is broken from all the cut cocaine i've taken all this time

Does anyone like the RC theme? I discovered it recently and it caught my attention. but the pills, to buy 3fma I buy real amphetamine that is cheap

 

[UWe9o12jkied91d]

I read in a book somebody had really clean 4-fluoro, twice purified and he had no discomfort with sulphate.The corresponding aldehyde and propene however...close to benzil chloride if in hot solution.

 

[sadow]

I read in a book somebody had really clean 4-fluoro, twice purified and he had no discomfort with sulphate.The corresponding aldehyde and propene however...close to benzil chloride if in hot solution.

UWe9o12jkied91dand how can i purify it? If it is very complicated, could I crystallize it?

 

[Mr Good Cat]

You can perform acid base a/b purification, check out the thread in this section.Instead of solvent extraction you can do steam distillation for max purity.
You can wash salt with dry acetone.
You can recrystalize from hot alcohol.

That's about what you could do practically.

UWe9o12jkied91dIf we are talking about steam distillation of the FB performed w/o expensive lab equipment, I mean with a basic distillation kit + hotplate + vacuum compressor, how much time does it usually take to distill 500 ml of the FB and what is expected yield in percentage? Probably surface temperature must be controlled between 110-130, right?

 

[UWe9o12jkied91d]

If we are talking about steam distillation of the FB performed w/o expensive lab equipment, I mean with a basic distillation kit + hotplate + vacuum compressor, how much time does it usually take to distill 500 ml of the FB and what is expected yield in percentage? Probably surface temperature must be controlled between 110-130, right?

Policja PolskaCan't say exactly but basic is all you need, no vacuum needed.Besides I have never distilled 500ml of base (excluding solvents).
Losses are practically 0 because in fact you are removing your impurities and solvent, not product.On this subject I have tried both under N2 flux and atmospheric and it dosen't make much difference.
Your RM will go up to 110 ish at most depending on water soluble impurities, no idea about surface temperature of the plate, temp. is measured with probe inside usually, the surface of the plate dosen't tell you that much.
It is important if you are using a plate to wrap your apparatus in foil to insulate as well as possible, for quick and trouble free results your whole installation needs to be hot up to the point at which the condenser start cooling the vapor.

 

[sadow]

Hello, I did a cleaning with IPA, I published in the amphetamine purification thread if someone wants to keep an eye on it and give me a hand