JWH-018 Syntese-video

[Amynosha]

the output of jwh-018 in this video is quite diluted but in the video of producing hashish , it has a high concentration. is there a difference between the two, or does another process have to be done on it to reach a high concentration?

 

[HIGGS BOSSON]

It is possible to increase the concentration by evaporation and crystallization. But these manipulations can be skipped and the resulting product can be used in the manufacture of synthetic hashish. This does not affect the effect, only the calculation of the dosage in the final product.

 

[smarties]

can you apply the end product on a paper sheet and smoke it? or how is it applied on a paper sheet

 

[kontol2004]

my aluminum chloride cant dissolve in dcm
1. Why?
2. whats the alternative for aluminum chloride or the alternative of dcm?
3. how do i increase solubility of aluminum chloride in dcm?
Thank u very much

 

[G.Patton]

You can heat the mixture to dissolve it and then cool it down as it's said in the step 4.

 

[kontol2004]

Hai thank u so much for replying, i might try it again, but can i use dichloroethane instead of dcm?

 

[G.Patton]

I don't know. I haven't tried this solvent.

 

[kontol2004]

my end product is greenish powder form, am i doing it right? i obtain 3 naphthoyl indole the same like in the video, but my end product result different. what am i doing wrong?

 

[kontol2004]

hello sir, my end product is red oily and sticky like a glue, i have tried to dry it for 48hours it still in form of red sticky oil. what did i do wrong?
thank you

 

[William Dampier]

It should be a viscous oil, but not red. Ideally, it would be a clear, light yellow oil, capable of crystallization under certain conditions. Upon slight heating, it should become liquid and flowable.