Amphetamine synthesis from P2NP via Al/Hg (video)

[NieDoswiadczony]

what is the way to check the free base of amphetamine oil -A whether it is good and whether the synthesis was successful

 

[Johnny Ringo]

First indicator is ph result. Another is the smell and if it converts to sulfate when you add acid you should be fine. If you wash it and filter it I think its pretty safe that even if you fucked up its at least clean shit that doesnt harm you. But I'm no expert I would recommend you text a guy that is in a high position on this site he can tell you for sure.

 

[nofuckups]

even with all these, it can be a byproduct salt instead of amphetamine sulfate. These are not good enough signs. Make proper tests after saltifying a batch to ensure it's actually amphetamine. You can try burning it(if it's some byproduct like sodium sulfate, it won't burn with ligher flame(melting point is 800'C+) but amph sulphate would melt/evaporate). Taste can be a good sign too. If soapy or salty, it's likely contaminated. There are various methods to know this but what you described tell nothing much about it.

 

[NieDoswiadczony]

and some way to check the free base of oil And is it ok? because I prefer to be sure, I do as described and in the video, everything comes out the same, i.e. after adding NaOh two layers separate the top one is yellow ph 11-12 after diluting acetone and sulfuric acid from the first drops flakes form if I reach ph 6 then I have a thick white form like yogurt-cream

 

[NieDoswiadczony]

Hello everyone, after precipitation from the free base of Amphate sulphate with sulphuric acid to pH 6 I filtered, dried, evaporated the solvent Acetone, the colour remained white, I made a test whether it would burn above 200 degrees, it began to melt and evaporated? I tried the sulphate on the tongue, the taste was very bitter, the smell was delicate, chemical? I took 10 ml of distilled water and threw in about 1-1.5 g of sulphate, I stirred gently and the water was as if I had not thrown anything into it, clean. so it is probably ok? also how can someone advise me in the reaction after adding p2np already, because the temperature will calm down in about 30 minutes, how the colour should be better because in one film it is dark grey and in the other light, Sziwy, does it have any effect on the quality, sorry for my questions, he gave you are obvious and I would like to know for sure that I do not know

 

[NieDoswiadczony]

something might be happening if the reaction is not cooled below 60 degrees but for example 70 degrees, can it be noticed, if so, any tips?