Cooking meth for the very first time.

[03wise03]

Can someone explain the basic things about meth cooking and how can i start it? i have the pseudo but dunno any other things
I want to make around 3.5 ounces

 

[Frit Buchner]

Rhodium: Drug Chemistry Archive

 

[Never to sleep]

Can't tell you anything else other than start reading up on the forum. There is more information than you need for what you're trying to do. I try to help people but it seems you did not spend half an hour reading the posts regarding your topic. If you had I cannot imagine I'd ask such a broad question.

 

[03wise03]

Can't tell you anything else other than start reading up on the forum. There is more information than you need for what you're trying to do. I try to help people but it seems you did not spend half an hour reading the posts regarding your topic. If you had I cannot imagine I'd ask such a broad question.

Never to sleepi dont understand a shit is so fucking complicated............like i want a video or something

 

[Frit Buchner]

i dont understand a shit is so fucking complicated............like i want a video or something

03wise03Bro there are literally videos step by step on this site. Meth is basically garbage, the appeal of it was it is so easy to make when you could go to Walmart and buy 10-50 packs of pseudoephedrine. There's drugs out there that will blow your heart out of your chest at 35mg. And it's not expensive.

 

[Frit Buchner]

You are reducing ephedrine, pseudoephedrine, norephedrine, phenylpropylamine or phenylacetalcarbonol by 1 oxygen atom.

 

[Tincan88]

You are reducing ephedrine, pseudoephedrine, norephedrine, phenylpropylamine or phenylacetalcarbonol by 1 oxygen atom.

Frit BuchnerAfter I lye wash my reaction could I draw the oil off and distill it to clean up end product. And when the red and iodine react to make hi it’s a gas so does it have to have ho2 to stay in the flask.?

 

[metux]

Take 5litre plastic jar,make amalgamation,after yours aliuminium is ready,add 100mil metylamine 40% into metanol,add 10mil bmk,mix,and add to the reaction vessel,,and wait until starts heating,add ballon,and shake every 10 min 2h ,add some Naoh,and wait 2h more,then all aliuminium disolves and becomes grey sludge,distill, and hcl gas,or any other metod you choise,but first read basics,how to make good amalgamation.

 

[metux]

Take 5litre plastic jar,make amalgamation,after yours aliuminium is ready,add 100mil metylamine 40% into metanol,add 10mil bmk,mix,and add to the reaction vessel,,and wait until starts heating,add ballon,and shake every 10 min 2h ,add some Naoh,and wait 2h more,then all aliuminium disolves and becomes grey sludge,distill, and hcl gas,or any other metod you choise,but first read basics,how to make good amalgamation.

metux40mil 40%metylamine in water,for 10mil bmk.

 

[Frit Buchner]

He's doing hydridoic acid/ phosphorus, no methylamine involved. Like I said on my wall, there's no benefit to distillation. Maybe you would gain 1-2% purity but the weight you would lose is a lot more percent. Adding water isn't preferred unless you have to, to kick it off, then it's a couple ml only

 

[Tincan88]

So would it be better to crystallize it. With gas and recrystalize in shards by heating it up in toluene . Would it shard up that way

 

[Frit Buchner]

Pretty sure you would want a dual solvent for best results. I'm thinking extract the base with nonpolar bubble it or acidify to precipitate then recrystallize in dual solvent

 

[Tincan88]

What is dual solvents. Like a mix of toluene and naphtha ?

 

[Frit Buchner]

Like that but probably not that specifically the lesser solvent is one the target isn't soluble in. I believe there is a recrystallization video in the video section that will tell you what is best and explain why